Conduit Rat™ Installation

Below you will find instructions for installing the Conduit Rat.

1. Make a clean cut of 1/8″ fish tape.

2. Unscrew cap from base of the Conduit Rat™; separate the Conduit Rat™ into point and base. Next, slide base onto the end of the fish tape.

2. Unscrew cap from base of the Conduit Rat™; separate the Conduit Rat™ into point and base. Next, slide base onto the end of the fish tape.

4. Connect point of ConduitRat™ with base of the Conduit Rat™ on fish tape. Now Conduit Rat is ready to use.

**DW04 ONLY**
5. After fish tape has been inserted into base, insert set screw all the way into the base and screw cap into the base.


Watch a short video on how to install the CONDUIT RAT onto your 1/8″ fish tape.